Thuong: 10 June 2007

I finished testing the sensor circuit and finalize the design as bellow:
sensor.GIF

This design gives us the flexibility to create many shapes for the doll’s body while keeping the QTC sheet lying flat on the PCB surface. The layer of cloth makes the surface softer and much nicer to touch. I tested this design using the oscilloscope and it gave quite good response. For a more accurate result I am planning to test it using the equipment from Impact lab so that later I can code the firmware accordingly.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-Share Alike 2.5 License.